Injection molded parts deforms
Description
Injection molded parts that cannot be copied exactly as cavity size, some parts are torn, bent or deformed.
Preview
Causes
|
Possible causes
|
Suggested solution
|
Injection molding machine |
Parts eject while they are too hot. |
1. Increase cooldown.
|
2. Reduce melt temperature.
|
3. Increase the total cycle time.
|
4. Reduce mold temperature.
|
Mold |
1. Mold sinks too deeply. |
Reduce the depth of the depression, and RADIUS.
|
2. Apex PIN number is too small or too little.
|
Increasre the number of top pin diameter or.
|
3. The movement of the machinery is not uniform.
|
Check out balance and smooth nature of mechanical movement.
|
4. The ribs use in injection molding line or the wheel design was incorrect. |
Rib used on lines, hubs and networks, such as the maximum allowable slope.
|
5. Mold surface finish difference. |
Polish mold surface.
|
|